This is a masking set for the Hasegawa F-104G. The masks are cut from yellow tape, similar to Eduard masks and the set includes masks for all three sections of the Hasegawa F-104G as well as masks for each of the tires. There are three separate masks for the three windscreen panels and there are two masks for both of the other two sections of the canopy. As with Eduard’s masks, the masks for the larger portions of the canopy establish the borders or the canopy leaving an open section in the middle that will need to be filled with either liquid mask, scotch tape or some other materials to protect the center of the canopy section.

The set also includes masks for the wheel allowing the tires to be painted black, the masks applied and the for the wheel hubs to be painted. As with the mask for the larger portions of the canopy, the areas outside of mask will need to be covered with some other material to keep paint off of the rest of the wheel.

Not too long ago, Trumpeter gave us a brand new, scribed 1/48th scale A-37 to play with and Scale Aircraft Conversions were not very far behind with a white metal landing gear to help support all of the added nose weight to prevent a tail sitter.

There are six total parts on two frets, with the nose gear being separate, The way they are cast makes cleanup of the parts much easier than the plastic kit parts. And, I must say they are every bit as clean and accurate as the kit parts. A cheap and welcome addition to the Trumpeter kit. I highly recommend this gear replacement.

My thanks to Scale Aircraft Conversions and IPMS for the review sample.

Eduard has come out with several photo etch sets for the 1/200 Scale, Merit, USS Hornet CV-8 (kit# 62001) and this is one of them. Part 4 provides detail parts to upgrade the 20 mm Oerlikon AA Guns.

The set includes a large sheet of photo etch with a lot of little parts. You get new gun shields and brackets, sights, forward and aft ammo drum covers with handles, elevation wheels and a harness for the gunner. Also included is a new deck (nice looking non-skid) that the guns sit on. You get two options one with the expended ammo canister and one without.

Assembly is straight forward but extremely fiddly. There are a bunch of very tiny parts that need to be bent and shaped. Most of the small parts are hard to hold and glue at the same time. This makes for a time consuming and sometimes aggravating assembly. Thank you Eduard for providing extra parts. There are only 30 of these mounts so pace yourself accordingly.