Review

Hobbyboss has released the main production variant of the Me-262: the A-1a version. The kit comes in 13 sprues, a clear sprue for the canopy and a metal nose wheel well to prevent having a ‘tail sitter’. The sprues are cleanly molded, free of flash and with well-defined recessed panel lines.

The model has a full interior, consisting of a nose gun bay, fully detailed cockpit and main landing gear bay plus a nicely detailed back fuselage (with a radio set and a compass set). However the detail in the back fuselage is pretty much impossible to see once the model is finished. There is only one service panel and it is not large enough as to allow viewing all that detail.

Initial Impression

The kit comes in a two part box, with a card stock cover and corrugated base providing very good protection for the kit. The front shows the five figures in one street scene and one side shows each figure individually.

Upon opening the box, we find the kit and instructions. The front of the instructions show the sprues with part numbers. A color list is included with Model Master stock numbers and the color names in Russian and English. The opposite side of the instructions shows drawings of the completed figures with part numbers in black and color call outs in red. The color guide is more useful since the sprue layout keeps each figure’s parts together.

The parts are arranged one one sprue of light brown plastic, which is relatively soft and responds well to Plastruct Cement. Each figure’s parts are kept in one corner of the spue with the last figure extending down the middle.

The U.S. Navy started converting SH-3A and SH-3D Sea King Helicopters into the Utility version designated SH-3G, eventually converting 105 early airframes into this version. The conversion included removing all of the anti-submarine warfare (ASW) gear and provisions to install 175 gallon external fuel tanks on the lower sponson supports. The G model was also outfitted with an improved refueling system that would allow it to Hover In-flight. Using this system it could hover over a ship and using the rescue hoist cable, bring the refueling hose aboard and fuel. The Navy also strengthened the load area of the floor to handle heavier loads. All SH-3G models were fitted with smaller non-ASW sponsons since it was no longer being used in the ASW role. Some of the earlier conversions were fitted with a gun mount for an M60 machine gun or the 7.62 mm minigun. The main job of this helicopter was ferrying equipment and personnel from ship to shore and back.