What You Get

A 2 ¾ by 5 1/8 inch 2-piece cardboard card wrapped in clear plastic containing a small Ziploc bag with Instructions and another card with a small plastic bag holding 20 barrels taped to the card (Figure 1). For no blast bag mounts (-058), each barrel is 7mm long with a 1mm tab at the end. For mounts with blast bags, each barrel is 4.5mm long with a 1mm tab at the end (Figure 2). The tip has a fine hole that is difficult to see, but it’s there.

This is a replacement canopy for Sweet’s 1/144 Hurricanes. The Sweet kit is a really great Hurricane, very nice to build, with great fit. The kit canopy is molded as a solid piece, very thick. Well, for a 1/144 kit it’s very thick. There’s no hollow part inside the canopy, it’s just a chunk of nicely molded clear plastic. But that’s not why I really, really appreciated this review item. When I got the canopies in the mail, I got out a kit I bought at a local swap meet. The kit comes with two complete aircraft. Except this box only had ONE CANOPY!! That’s when I really knew I owed Phil Peterson and John Noack a big thank you for this one.

The Douglas A-1 series of aircraft (known as the AD prior to 1962) was designed as an attack aircraft that could carry a heavy load of ordinance.

Quickboost’s A-1J Tailwheel brings an improvement to the Hasegawa A-1 kit. This part replaces only the bottom part of the strut, and not the entire strut. The wheel itself is separate from the strut.

I cut the bottom portion of the tailwheel strut where indicated in this kit’s instructions, and then glued the replacement strut piece into place using cyanoacrylate glue. Once the glue was dry, I painted the strut, installed the wheel onto the strut, and installed the strut onto the model.

I highly recommend this detail set for the Hasegawa kit. My thanks to Quickboost for the review sample.