This is a nice kit and a fun build. This kit is the second version of the ’62 Corvette released by Revell, following the 2012 release of the ’62 Corvette Roadster 2’n1 kit. The ’62 Gasser kit is for skill level III and ages 12+. The kit did not seem that difficult, and I think it would be fun for even advanced beginners.

Background

The Gasser kit recreates the ’62 Corvette converted by D&M Corvette Specialists into a street gasser with a blown small block Chevy engine. The original car’s body is nearly stock, and is replicated in the kit by the same stock body used in the Revell ’62 Roadster.

The instructions and decals have a 2013 copyright. The underside of the floor pan/interior has a 2012 copyright and is likely the same as the earlier ’62 Roadster kit. Online references indicate that the frame is a new tooling for the Gasser kit, and includes the chromed Gasser suspension.

Scale Aircraft Conversions’ 1/48 Gloster Javelin landing gear set is a full replacement in white metal for both main gear legs and the nose gear. In many cases SAC will assemble some of the kit parts prior to casting; however, in this case they have cast the parts individually. Additionally, they have also cleaned up the gear and filled the sinkholes that were present on the original plastic parts.

The main gear consists of four parts for each side: a main gear leg, two retraction arms and compression scissors. The nose gear consists of the gear leg with one side wheel-cover, the opposite side wheel-cover and a retraction arm.

Detail is crisper on the metal gear than on the kit’s plastic parts. The replacement parts are a drop fit with no issues what so ever. The replacement for kit part G21 needs to be threaded through an opening in the existing kit parts, but if you take your time and do this carefully you should have no problems.

MiniArt is a Ukraine company that was established in 2001 and released their first kit in 2003. They are well known for their Diorama series, but the have released many armored vehicles, figure sets and accessory sets over the past several years.

This figure set comes in a end opening cardboard box. The instructions for assembling the figures is on the rear of the box. The kit comes with two sprues and these contain the five figures and equipment for them.

The figures are molded in a light grey plastic. There is just a slight amount of flash on the parts, with the biggest issue being the clean up of mold lines. The figures are pretty well detailed, just be careful in your clean up of the mold lines as you might lose some details. Painting instructions and paints are called out on the rear of the box. They list several different paint manufacturers.