After ten years of Countach production, the 1985 four valve per cylinder “Quattrovalvole“ V-12 coupled with a new fuel injection system was a significant upgrade. If that wasn’t enough for auto enthusiast they only made 610 of them which sold out immediately.

This review covers the skill level 5 (ages 14 years and older) 2016 release of the Lamborghini Countach 5000 Quattrovalvole 1:24 Scale Italeri Model Kit #3683. This kit is molded in white, grey, black, chrome, and clear with vinyl tires. Decals are made for the detailed interior and the chassis is made in multiple parts for enhanced finishing. The motor is highly detailed and can be viewed through the open engine cover. The body is also a multi-part unit crisply molded and proportionally correct. Finished dimensions are Length 7-¼”, Width 3”, Height 2”.

This is a photoetch interior set for the Revell Ventura Mk. II. This set includes two photoetch sheets. One is colored and adds a lot of needed detail to the cockpit. The photoetch really make the cockpit stand out.

In the packet is:

• 1 colored photoetch sheet
• 1 photoetch sheet
• 1 instruction sheet

Summary

This is a fantastic set for a kit that needs it. The cockpit parts really add some detail. I did find some of the small parts were very tricky to add. Also, I would recommend installing the assembled parts 34 and 14 into part 7 before you fully form it. The set also adds details such as magazine boxes, navigators table, turret gun control panels, grab handles, and additional seat details.

Thanks go to Eduard for providing this set to review and IPMS USA for allowing me to review it for them.

The L-29 Delfin was a jet-powered trainer airplane that was designed by the Aero Company of Czechoslovakia. An excellent kit of the Delfin has recently been released in 1/72 scale by AMK. Although this kit, in my opinion, is very good, our friends at Aires/Quickboost have found some areas where the accuracy of various parts can be improved.

This set from Aires provides replacements for the kit elevator, rudder, and flaps. The four flap parts provide additional surface detail but mainly provide very sharp trailing edges. The flap parts also have some added detail molded into the sides of the flap parts. These parts must be carefully removed from their molding sprues because of their fine mounting struts.

The new elevator offers a slight improvement over the kit part. Surface detail is about the same but the Aires part has finer elevator tip counterbalances and of course, the trailing edges are sharp.