The Kit

The plastic motorcycle parts are on a single sprue, the figure on a separate sprue, plus a sprue of clear parts, a set of photo etched parts, and a decal sheet with markings for the motorcycle and uniform patches for the figure. The instruction sheet is very nice: Large, clear, and in color.

The parts are all very cleanly molded, no issues with flash, sink holes or ejector pin marks, and the detail is crisp. The kit also includes plastic jigs for bending the photoetched parts.

The Build

Following the instructions, the build begins with bending the photo-etched parts. The spokes for the wheels are no problem, but the fender supports for the front wheel assembly were a bit challenging. In order to get the proper curve where the supports attach to the front fender, I used a small paintbrush handle, pressing into the cutting matt to get the proper curvature. I couldn’t get a sufficiently curved bend using the jig alone.

Airfix continues to knock out quality 1/48th kits as they continue surging ahead making a wide variety of kits. Their newest offering is a 1/48th version of the Bedford MWD truck. A 4x2 vehicle that entered service right before the war started, the Bedford saw service in France in 1940 and would continue to service with the RAF and the British Army after they re-entered the continent in June, 1944. The kit provides parts, decals, and paint schemes for two vehicles – the early version that served in France in 1940 and the later version that served with the RAF in 1943.

I recently built and reviewed Brengun’s USN Tow Tractor (BRL 144025) used on aircraft carriers. One thing that I said was missing was the tow bar to allow the tractor to move the planes around the deck. So here it is.

The entire kit is a single resin cast and a single PE fret. The resin parts are the bars for the tow bar. The PE is the connectors to hook the assembly to the tractor at one end and the aircraft at the other.

Assembly Preparation

The assembly is both easy and difficult. The easy part is that there aren’t a lot of parts, and they are logically set up. The difficult part is that the PE parts are all very small and easy to lose. One way I overcome this difficulty is using a jeweler’s apron, which anchors to my workbench at one end, and the other end has a loop which is around my neck. This way if I drop a part, it usually falls into the apron, where it can be recovered. The carpet monster is bereft.