This boarding ladder is one of those spiffy little accessories which can add a lot to the presentation of a model. In this case, it’s being added to an old Attack kit of a Pakistani Shenyang JJ-5 trainer (based on the MiG-17).

I cut the ladder itself loose from the PE sprue, and I also cut out the ladder pads. These are very tiny in 1/144, so be really careful.

I bent the sides of the ladder using a “high-tech” tool, namely a pair of “duckbill” pliers. The pliers have a decent grip and good straight sides. I took a photo of the ladder with one side bent, then the other. I spent a few minutes getting the sides trued up and made sure the ladder steps were square with the side rails.

Once the ladder was trued up, I applied a spot of thick CA to one of the ladder pads and touched the ladder top to the CA. I then trued up the pad with the ladder top. Same with the other ladder pad.

Signal was a propaganda publication by the German Wehrmacht stylized after Life magazine and published from 1940–1945. It was aimed at those in occupied, neutral, and allied countries, but it was never sold in Germany itself. Published in almost 30 languages, it was even available in the USA until December 1941! The magazine was kept under the control of the army and thus was independent of the Nazi Propaganda Ministry. This did not prevent it from being a propaganda laden publication. While it chronicled the conditions faced in combat by Germany and her allies, it also had a strong political message advocating for a “united Europe” under the “New Order” and for supporting the fight against the communists—even highlighting those former enemy combatants that chose to fight for the Nazis!

To start, my thanks to Aires for providing IPMS/USA with this figure to review! One of six in this review series, each shows a passion and dedication Aires have to providing the finest resin products. We appreciate your support, with the usual nod to IPMS/USA leadership for allowing me to review these figures.

Produced under the Aerobonus branch of Aires, this 1/48 scale figure is a Russian pilot sitting in a KS-4 ejection seat. The pilot, consisting of a torso in the seat, two separate arms, and a separate head/helmet, can be assembled in many ways. As designed, the head is supposed to be looking left, the right arm and hand are positioned for a grip on the control column, and the left arm is where the throttle would be. Also included with each set are painting instructions in color!