With the ever growing number of 1/32 scale rigged aircraft kits on the market, Eduard now offers a generic photo-etched set of 1/32 scale flying wires and stretchers (AKA Turnbuckles). Metal flying wires are a logical and much desired aftermarket detail set for model builders wishing to accurately replicate the metal wires used on most Allied aircraft built after 1915/16. Unlike the majority of other p/e sets cataloged by Eduard, a specific aircraft type (or kit) is not specified. Instead, the fret includes 33 anchoring rings, wires of differing lengths with a stretcher near one end and others including stretchers with tabs that may be used as attachment points to fit a variety of aircraft (see the photo of the fret below). Model builders will need to determine if this set fits their needs. I say ‘fits’ because the wires themselves are provided in only two lengths…2 1/14” and 5 1/8”.

By 1916, the little Nieuport 11, also known to the French Militaire by its initials BB (which the French pronounced bébé), had succeeded in putting an end to the Fokker Scourge and therefore gaining the respect of ally and foe alike. A higher horsepower version, known as the Nieuport 17 followed and built on that legacy, becoming the preferred mount for many of the Allies’ first generation Aces. But subsequent efforts to continually improve upon Nieuport’s basic Vee-strutter design fell short of expectations with the introduction of the 24, 24bis and later the 27. Failing to match the performance of a new generation of fighters, these Nieuport designs generated little enthusiasm among French pilots who instead looked forward to flying the much-desired new SPAD. Unfortunately, SPAD production could not match demand and there was a war to fight so the new Nieuport fighters began arriving at the front in early 1917.

The Navy FJ-4 was, to many people, the culmination of the basic North American Sabre Jet. This final naval variant featured a more powerful engine which required a larger intake, a shorter, deeper fuselage, a larger tail, larger wing area and a longer nose gear. Its front line service was short, however. Although the FJ-4B was loved by its pilots, by the late ‘50’s the Fury was being phased out by newer, less expensive fighter and attack aircraft. They referred to it as the “Cadillac”, while its counterpart and eventual replacement, the A4D, was referred to as the “Tinkertoy”.

Emhar issued the FJ-4B in 1/72nd scale in 1990 and is a great kit. There are really only two shortfalls of the kit; the first being a rather basic cockpit and the second being a crude, short exhaust/jet pipe. Pavla has recently released resin detail parts for the cockpit and the exhaust.