The Kit

This item comes as a single small PE Fret. It’s the boarding ladder for a 1/144 Skyhawk, the base kit by Platz, and it’s been reboxed by Eduard.

Assembly and Installation

I cut the base part from the fret. I formed the ladder legs to 90 degrees from the steps. Then I cut the brace that goes on under the platform, then added the platform. The steps were next, and then the two braces that run from the step support to under the platform.

I painted the ladder assembly bright yellow. I also painted the steps and top of the platform flat black, as anti-slip coatings. The wheels were then painted flat black and added to the bottom of the ladder.

For those who prefer the smaller footprint of 1/72 scale WWII German subjects, Hauler has released this set of license plates, which look great for their size. While I typically start my reviews with a little history on the item that I am reviewing, when it comes to license plates, there is just not much to write. What I can tell you is that on a single photoetched fret, Hauler provides 58 plates of the three styles used most during the war. 27 of the plates are etched with a raised outer edge, while the remaining 31 are flat plates.

These plates will be an easy item to add to any kit to either replace the plastic equivalent or can be added if the kit neglected to add the plate(s). While no instructions are provided, none are needed as you can replace the kit plate(s) following those instructions for location or using reference photos to install them in the correct location.

In his organization of this book, Mr. Campbell provides a logical approach to this ground combat at Verdun. The Table of Contents provides for the basic outline:

• Introduction
• The opposing sides
• Bois des Caures
• Mort-Homme
• Fort Vaux
• Analysis
• Aftermath
• Unit Organizations
• Bibliography
• Index

The publishers’ notes include this summary of Campbell’s book: