Eduard has produced a beautifully cast 1/48 version of one of the most current US Military’s air-delivered weapons – the AGM-154C1 (Block II) Joint Stand-off Weapon (JSOW).
The Wikipedia article for the AGM-154 says:
With regard to aircraft that have operated from the decks of a British aircraft carrier, there can be little doubt that the McDonnell Douglas Phantom FG.1 was the most spectacular. Purchased to replace the Sea Vixen in the role of all-weather fleet defense, the Phantom was the largest and heaviest aircraft ever operated from a British carrier and required a special breed of airmen to fly them.
The AN/ALQ-131 electronic countermeasures pod is used by the US Air Force, the Air National Guard and several US allies. The pod is a modular design that can be configured to address a variety of threats. It is cleared for use on the F-4, F-5, F-16, F-111, A-10, F-15 and C-130.
This set depicts the deep version of the ALQ-131 pod, often seen on an outer wing pylon of an A-10 or sometimes a C-130. The set is very straightforward consisting of the pod, two mounting lugs and a decal sheet.
The AN/ALQ-131 electronic countermeasures pod is used by the US Air Force, the Air National Guard and several US allies since the 80’s. The pod is a modular design that can be configured to address a variety of threats. It is cleared for use on the F-4, F-5, F-16, F-111, A-10, F-15 and C-130.
This set depicts the shallow version of the ALQ-131 pod, often seen on the centerline pylon of USAF F-16s or an outer wing pylon of the A-10. I was also able to find a photo online of one mounted under the forward fuselage of an Australian F-111. The set is very straightforward consisting of the pod, two mounting lugs and a decal sheet.
Quickboost, an Aires Resin division, continues to produce quick and simple resin upgrades for a wide variety of subjects. The detail parts are crisply cast and often add to or correct kit items.
This review covers replacement propeller blades for Hasegawa’s 1/32 Fw-190D-9. In overall dimensions, length and width, the kit and resin parts are very comparable with maybe .001 difference in length. The portion that differs is at the propeller base. The kit part starts to widen just a few millimeters from the base whereas the Quickboost parts taper more gradually and better match online profiles of the actual blades.
The MD-3 Ground Power unit is a portable generator designed to provide either DC or AC power to aircraft while on the ground. It is powered by a 180 hp Continental engine to drive its generators. Its initial design was for the B-47 aircraft but it can also be used for other cold war era planes such as F-84, F-86 through to F-4 Phantoms from 1960 to 1970, and this is by no means an exhaustive list.
The V-2 was the first operational ballistic missile. It didn’t use an aiming system as such but was launched in the exact direction of the target. The engine was cut off when the missile was at the correct speed and altitude to allow it to coast to the target. The 2150-pound warhead could do a large amount of damage, and, unlike the V-1 there was no way to intercept a V-2. A V-2 was also the first vehicle to go into outer space, reaching an altitude of 100 km. (62 miles).
The V-2 was a “vengeance” weapon, to answer the Allied bombing of German cities. The main targets were London, Antwerp and Liege. Over 3000 V-2s were launched against these cities.
This kit is mostly resin, with some PE details for the launch stand.
If you have a Roden or Eduard 1/48 Gloster Gladiator kit then Quickboost has come through with another nice item to add a little more detail to it. The Quickboost doors are molded well and the detail is a lot crisper than the kit doors. If you are going to detail the cockpit you will want to have the doors posed open so you can see that detail and these will make it look even nicer. I highly recommend these.
I would like to thank Aires/Quickboost for supplying this and IPMS for the letting me review this item.
If you have the Roden or Eduard 1/48 Gloster Gladiator, Aires has come through with this very nice item to add a little crisper detail to it. The wheels are nicely molded and, with the masks that are provided, easy to paint. I highly recommend these to anyone with this kit.
I would like to thank Aires for providing this fine detail set and to the IPMS for allowing me to review them.
AoA (Angle of Attack) decals: Continuing their focus on Vietnam War subjects. We sincerely appreciate AoA sending IPMS/USA their latest release for review (and thanks also to IPMS USA Reviewer corps leadership for sending this sheet my way).
This decal set includes stenciling for two aircraft, so you can get two, maybe three marking options out of your investment if you are careful. The modeler is up front provided options to build at least two of 14 different O-2 aircraft.
