This is a very nice Photo Etch set for the ICM JU 88A-4 Kit. This set adds a lot of extra detail to the interior of the kit, plus additional exterior parts as a bonus.

The photo etch parts are for the:

• Cockpit side panels
• Instrument panel, pedals, radio equipment and various control details,
• AMMO Magazine boxes, Bullet belts, stowage bins, and Bomb sight,
• Machine guns handles, sights and mounts

In the Packet is;

History

The J2M2 Raiden (Jack) was designed to achieve a high rate of climb in order to intercept incoming bombers. The aircraft went into full scale production in 1943 and early models included two cowl 7.7mm machine guns and 20mm wing cannons. Later versions omitted the cowl guns and relied on the heavy wing armament instead. It was used extensively late in the war as a bomber interceptor and proved to be one of favorite aircraft of Japanese pilots for this task. There were a total of about 500 aircraft built by the end of World War II and only one surviving example of this aircraft today located at the Planes of Fame Museum in Chino, CA.

This is a nice photoetch set for the ICM Ju 88A-4. This set adds a lot of addition detail to the exterior and make it look even better.

The photo etch parts are for the:

• Landing gear details
• Engine and engine mount details
• Land gear bay details
• Engine bay doors

In the packet is:

• 1 large photoetch sheet
• 1 clear film sheet
• 1 instruction sheet

Summary

This is great photoetch set to bring a lot of additional details to this very good kit. The engine parts are great as the engine access panels can be left open. The only issues I found was with the rear wheel bay parts which need to be carefully installed. Also the side brackets that install in the land gear bay are trick when you mount the engine and gear bays to the wing and can pop out.

With that being said the set adds some realistic detail.