The Tamiya F-14A Tomcat set a standard for plastic model kits. If there is a drawback it is that the aircraft can only be built as a very early Tomcat. Some things that need to be addressed to change your Tomcat to a later A model and B model is the so called Beaver Tail, as well as, the chin pods and gun vents. Quickboost addresses all of these areas with individual upgrades.

This offering is a single piece of light grey resin. It represents the beaver tail as seen on later F-14As, B, and Ds. It includes the fuel dump port and the ECM pod. Removing the part from the pour stub is easy enough. It is a drop in replacement part for the kit part. Simple and very easy to add.

If you want a later Tomcat then you need this part. No two ways about it. This part is an important addition from the Late F-14A onward. Now you just have to decide which chin pod you’ll need. Don’t forget the gun vent panel too.

Highly recommended

Quickbost has produced a replacement “football” radar antenna housing for the Academy 1/72 PBY Catalina kits. The resin replacement is a simple drop-in for the kit’s plastic parts. There is no modification required to the kit parts to use these resin replacements.

A side by side evaluation (see photos) indicates a replacement of superior detail that will provide a more accurate rendition of the radar antenna housing assembly. Check your references for the appropriate seat to use. Be sure to wash the parts in soapy water to remove mold release agents and prime prior to using your favorite modeling paints.

Highly recommended.

Thanks to the IPMS Reviewer Corps and Quickboost for the opportunity to review this item.

Overall Summary

I recommend this kit for any collection of USN submarine models. This kit is for intermediate-skill modelers, and will result in very nice representation of any of the short-hull Sturgeon class attack submarines that served in the U. S. Navy. Assembly was straight forward, with no major problems. No alignment pins or sockets are present in the kit design, and many parts may require addition of pins or wire for positive location. This is not a detraction from the kit, but something to think about when you start assembly. The resulting model looks proper in comparison to photographs and references.