The Tiger II Ausf.B, Konigstiger, King Tiger or Royal Tiger, as it was called depending where you were from, was the most powerful tank produced by the Germans. It became operational in July 1944, during the Invasion of Normandy. This formidable tank fought on the Western and Eastern Fronts until the end of World War II.

Hauler is located in the Czech Republic, and produces high quality photo-etched sets for AFVs, aircraft, cars, railway vehicles and resin accessories for dioramas and resin kits.

This set fits the 1/72 scale Revell Tiger II kit, and comes nicely packaged with the two photo etch frets inside individual clear plastic bag. The instructions are folded and everything is stapled to the folded over cardboard backing.

I’ve got my spray booth set up, my paint mixed, and the compressor has been powered up and its ready to go. The paint cup is attached to the airbrush with anticipation of an enjoyable painting session. I pull the trigger…………and nothing. After fiddling with the pressure and air adjustments on the airbrush and compressor, I realize that my airbrush is jammed up with dried paint. There’s not anything to do but shut down the painting session and get the airbrush cleaned up.

That is where Tamiya’s #87089 Airbrush Cleaner steps in. You’ll need a cleaner that can loosen and dissolve dried paint, and this product is very good at doing just that. You know the drill. Disassemble your airbrush and clean each part carefully and completely. I use a small wire brush dipped in some Airbrush Cleaner that has been poured into a very small cup. Wearing gloves, I carefully scrub the airbrush parts with the wire brush, dry them with a lint-free cloth and I’m ready to go!

The Su-25 is the Soviet equivalent of the A-10 first utilized in Afghanistan. This mud mover is pretty well represented in 1/48^th scale by KP/Smer. As always there are ways to improve what comes in the box.

Quickboost has taken to updating the Frogfoot to a whole different level. This particular set is designed to upgrade the lights. Packaged in a typical Quickboost resealable package with card stock backing has two resin sprues. The first is light grey resin which holds the two reflectors. The second resin part is molded in clear resin. It has the bulbs and two new clear resin lens.

To use the set you simply have to drill out the landing light hole in the wing. Then you paint the reflector, add the bulb, and use the clear resin lens. Done. Simple, easy and effective.

This light set will replace the kit parts which are not very accurate looking. The Quickboost set is very realistic, easy to use, and inexpensive.

Highly recommended.