Aires has issued several styles of exhausts for the current 1/48th scale kits on the market. These kits have either open or closed nozzles and for either the Hasegawa or Revell kit. So there are four sets in total. This set is for the Hasegawa series of F/A-18E/F kits and has closed nozzles. The set consists of six parts- two flame holders, two exhaust tubes and two closed nozzles. Casting is perfect. There are no flaws or blemishes.

The set is simplicity to use by removing the casting blocks from each of the six pieces, three per side. You can see in the comparison shots that the detail is much higher in the resin parts. The interior of the afterburner petals is much better and has the correct shape.

Here’s a great picture.

This is a masking set for the Hasegawa F-104G. The masks are cut from yellow tape, similar to Eduard masks and the set includes masks for all three sections of the Hasegawa F-104G as well as masks for each of the tires. There are three separate masks for the three windscreen panels and there are two masks for both of the other two sections of the canopy. As with Eduard’s masks, the masks for the larger portions of the canopy establish the borders or the canopy leaving an open section in the middle that will need to be filled with either liquid mask, scotch tape or some other materials to protect the center of the canopy section.

The set also includes masks for the wheel allowing the tires to be painted black, the masks applied and the for the wheel hubs to be painted. As with the mask for the larger portions of the canopy, the areas outside of mask will need to be covered with some other material to keep paint off of the rest of the wheel.

Not too long ago, Trumpeter gave us a brand new, scribed 1/48th scale A-37 to play with and Scale Aircraft Conversions were not very far behind with a white metal landing gear to help support all of the added nose weight to prevent a tail sitter.

There are six total parts on two frets, with the nose gear being separate, The way they are cast makes cleanup of the parts much easier than the plastic kit parts. And, I must say they are every bit as clean and accurate as the kit parts. A cheap and welcome addition to the Trumpeter kit. I highly recommend this gear replacement.

My thanks to Scale Aircraft Conversions and IPMS for the review sample.

Eduard has come out with several photo etch sets for the 1/200 Scale, Merit, USS Hornet CV-8 (kit# 62001) and this is one of them. Part 4 provides detail parts to upgrade the 20 mm Oerlikon AA Guns.

The set includes a large sheet of photo etch with a lot of little parts. You get new gun shields and brackets, sights, forward and aft ammo drum covers with handles, elevation wheels and a harness for the gunner. Also included is a new deck (nice looking non-skid) that the guns sit on. You get two options one with the expended ammo canister and one without.

Assembly is straight forward but extremely fiddly. There are a bunch of very tiny parts that need to be bent and shaped. Most of the small parts are hard to hold and glue at the same time. This makes for a time consuming and sometimes aggravating assembly. Thank you Eduard for providing extra parts. There are only 30 of these mounts so pace yourself accordingly.

This set consists of six resin replacements for the gear doors of the recent Airfix A-4B Skyhawk kit. The new doors are one-for-one replacements of the kit parts.

The parts are cast in a tan colored resin and are delightfully thin. All six doors are attached to a single casting block, but the attachment points are very thin and easily removed. Once removed the only clean-up is to lightly sand the edge where the parts were connected to the casting block. I painted the parts with Tamiya paint which adhered with no problem and was pleased just how well the details popped out with a light black wash.

This set is highly recommended as a nice upgrade to a great little kit of the Scooter.

Thank you to Aires for the review sample and to IMPS/USA for the opportunity to review it.