MiG-3 Seat with Safety Belts
Trumpeter’s 1/32 scale MiG-3 kit is quite nice and needs only a few changes to improve it. Some kit reviews have pointed out that number one on the list is enhancing cockpit details, and the seat is the most conspicuous item noted. Quickboost has now addressed that issue by offering a two-piece resin replacement that includes a high level of detail and nicely molded safety belts (the photos below show the level of detail on the front and back of each part). The two-piece seat is designed to fit in place of the kit’s three-piece seat parts. In the comparison photo below, the Quickboost seat (on the right) exhibits superior detail and avoids the ejector pin repair issue found in the kit’s seat back (on the left).
The parts are molded in Quickboost’s familiar gray resin on reasonably small casting blocks. The quality of the molding is flawless, with no bubbles, pinholes, or flash to deal with. A sharp #11 X-Acto blade or razor saw blade is the recommended tool for removing the parts from the casting block…and a quick swipe with a sanding stick can dress up the cut edges if necessary. However, caution is advised when removing the seat pan to avoid accidentally breaking off the two small support brackets that are molded along the back of the pan. They help to align the seat back at the proper angle.
Note that, because Quickboost aftermarket parts are cast in resin, they must be attached with super glue or epoxy cement.
This well-detailed seat is highly recommended. I appreciate Quickboost providing the review sample and thank IPMS/USA for the opportunity to review it.
Comments
Add new comment
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.