Bottom Line: Perfect to-scale 6” (152mm) barrels for Littorio and Garibaldi WW2 Italian warship classes

The latest secondary, or anti-torpedo boat, armament for new construction (Littorio battleship and Garibaldi light cruiser classes) was the 1936 model 152mm/55 caliber gun. This new gun was derived from the earlier 1926 and 1929 versions in use on then-current Regia Marina light cruisers. Two different versions were made – a monobloc construction by the original designer, Ansaldo, and heat-forced tubular element construction from OTO (used only in Vittorio Veneto and Roma battleships). Twin and triple turrets with independent cradles for each gun were made. Rate of fire was one round every 14 seconds. The guns were considered as satisfactory, but dispersion at long ranges was wide, attributable to the ammunition.

The Parts

Recently, Eduard released photoetched detail sets for the 1/72 scale Hobby Boss F-14A, and these included both an interior as well as an exterior set. Having been fortunate enough to receive both sets for review, I will begin with my evaluation of the interior detail set. Upon opening this set, you will find two frets of photoetched parts, one being pre-painted and self-adhesive, the other being unpainted metal with no adhesive, along with a single-sheet page of directions. This was my first experience with an Eduard self-adhesive detail set, and I greatly enjoyed the encounter. I will mention here that if you are modeling on a budget and needed to choose between the interior and exterior sets, that I would recommend the interior set.

History

During World War II, a total of 10,500 V-1 missiles were launched against Britain, of which over 3,900 were destroyed by air and ground defenses. Overall, the attack and subsequent damage could have been much worse, for by the end of the war the Germans had manufactured close to 32,000 flying bombs. The Allied defenses put forward to guard against the V-1 included 23,000 men and women with aircraft, guns, radar, and communications networks installed on coastal sites.

The average speed the V-1 was 350 mph and their average altitude was 3,000 to 4,000 ft. Fighter aircraft required excellent low altitude performance to intercept them and enough firepower to ensure that they were destroyed in the air rather than crash and detonate. Most aircraft were too slow to catch a V-1 unless they had a height advantage, allowing them to gain speed by diving on their target.

The KC-135 started as the Boeing Model 717, which was based on the Model 367-80. Boeing delivered 820 KC-135 and derivative models between 1957 and 1966. The KC- 135 has gone through many modifications over the years and is still in active U.S. Air Force service today.

This is the first time that I have ever gotten a Squadron Signal book upon its release and all I can say is wow! The book consists of eighty-eighty pages with almost every single photograph being in color except with a few that shows the KC-135 early in life.

Another very welcome offering from our friends at Scale Aircraft Conversions is their white metal landing gear set for SkunkModel Workshop’s 1/48 scale MQ-9 Reaper. Since reviewing the Reaper kit back in June of 2011, my sample has succumbed to the insatiable pull of gravity against its spindly injection-molded main struts, settling into a “low-rider” crouch with the low-hanging vertical stabilizer all but dragging in the dirt.

Enter SAC’s aftermarket set! Patterned from the kit parts, the SAC struts are a perfect fit to the base kit. Although some detail is softened in the casting process, they are still convincing in appearance and a necessity to preclude the dreaded “low-rider” effect of the kit struts.

I highly recommend this set for anyone building the 1/48 SkunkModel MQ-9 Reaper with gear down.