F6F-3/5/5N, Mk. I/II Hellcat Landing Gear

Published on
Review Author(s)
Scale
1/48
MSRP
$19.95
Product / Stock #
48499
Base Kit
Eduard Hellcat variants
Provided by: Scale Aircraft Conversions - Website: Visit Site

Scale Aircraft Conversions (SAC) provides white-metal alternative parts (mostly landing gear) for a wide variety of plastic aircraft kits. Their product number 48499 provides white-metal landing gear parts and a pitot tube for Eduards family of 1/48 scale F6F Hellcat kits. The parts come in a small blister pack. There are no instructions included, but it is easy to match the parts to their corresponding plastic parts in the Eduard instructions. Included in the package are the following: left and right gear legs and their braces and torque links, a tail gear leg with integral tail wheel, and a pitot tube.

The SAC parts have the same molding quality as the kit parts, and once they are primed are difficult to distinguish from the plastic parts except by weight. There are faint mold-parting lines on the gear legs, but the metal is so soft that they can be removed with the same tools that you use on plastic parts. Very fine brake-line detail is molded with the gear legs. The torque links in the Eduard kit are built up from four pieces (two for each gear leg). The SAC torque links are a single piece for each gear leg. Since the torque links are not structural in the finished model, you could use either plastic or metal parts depending on your preference. When installing the torque links, it can be difficult to keep left, right, up, and down sorted out. The tapered sides face the gear doors, and the wide side of the hinge joint faces down. Both the SAC and Eduard tailwheels are of the solid tire type used on aircraft carriers. If you want a pneumatic tailwheel tire of the type used by land-based planes you will have to source that elsewhere. The SAC parts are intended to be direct replacements of the Eduard parts and require no modifications to the base kit for use. The rectangular peg at the top of each gear leg is a snug fit into the corresponding holes in the Eduard gear bays. You may want to sand them a little and bevel the edges slightly to ease assembly.

If you are wondering if the SAC gear will work on your 1/48 scale Hasegawa Hellcats, the short answer is “No.” The Hasegawa kit has raised round sockets for the gear legs.

The SAC landing gear and pitot tube are equal in detail to the Eduard parts but offer an upgrade in strength to the parts that are most likely to be broken while handling or transporting your model. It is a lot easier to straighten a metal gear leg than to drill out and pin a broken plastic leg. Whether you are building a new Hellcat model or need to repair an older build, these SAC parts may be what you need. Thanks to Scale Aircraft Conversions and IPMS/USA for providing these parts for review.

Packaging

Comments

Add new comment

All comments are moderated to prevent spam


This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.