Quickboost has now released a resin aftermarket part that will add detail to any 1/32 F4U-1 kit on the market. It is actually an enlargement of Quickboost’s set 48 357 for 1/48 Corsairs. This set provides three ready-to-install F4U-1 Corsair pitot tubes cast in a flexible resin that likely will survive occasional bumps sometime experienced when a finished model is handled. The pitot tubes are molded in Quickboost’s familiar gray resin on a casting block with extended bars that protect the parts from damage in the package. They exhibit a much better pointed tip than those included in most 1/32 kits.
A sharp #11 x-Acto blade is the only tool needed to remove each pitot tube from the casting block and to shave off a thin casting gate that is molded on the side of the part to protect the tip detail.
This part is a direct replacement for a kit part and, because it is resin, should be attached with super glue or epoxy cement.