Just like the company name implies, this a quick boost for the exhausts on the old Eduard 1/48 Hawker Tempest kit.

Like the other products I’ve reviewed from this company, they are very well done and easy to remove from the casting blocks. I must admit, I requested these because, during the sanding phase of this project, I broke some of the stock exhaust stubs off. The kit parts and these replacements are installed from the inside before closing the fuselage halves. I was too far along to do it that way so, after chopping out the old stubs and trying to level the plate behind them, this is as close as I could get. There is no doubt in my mind they will fit perfectly when properly installed.

Master Box has provided 5 German infantry figures in dynamic poses that reflects the kit label “Cold Wind”. Typical of their products, the box front accurately reflects the final figures and the box rear has pictorial instructions on figure assembly. Pictures of the two sprues are provided on the rear, one is labeled A and the other B. The sprues themselves do not have this marking, but sprue A has parts for three figures and sprue B has parts for two figures. Part count for the sprues is 109 pieces, with 8 parts not being used. The plastic is a yellow/tan color, soft, and glues well with liquid cement.

The Soviet fighter Yak-3 is part of Zvezda’s new “Snap Fit” series. You get 45 medium gray hard plastic parts and two clear parts with minimal flash. The instructions are very well illustrated with seven sequences of assembly. The detail is exceptional and surprising for a snap fit kit. The three piece pilot figure is a work of art, with the seat pan molded to the pilot. A seat without pilot is also provided, should you wish that option. The kit is designed for snap assembly and can easily be assembled with no glue. However, I plan on using glue. Areas of concern are the sink marks on the upper wings (part 40) and front top cowling (part 41). Filler will definitely be required. You also get two finely detailed instrument panels, one to be used with kit supplied decals and the other with raised details for the instruments if you prefer to paint yours. You also have the option for wheels down or wheels up.