Description and History

Quoting from Dragon's web sitde product description:

“The kurzer 8cm Granatwerfer 42 (abbreviated to kz 8cm GrW 42) was developed as a lighter version of the standard 8cm GrW 34 mortar. It was commonly referred to as Stummelwerfer (“stump-thrower”) by troops. The smaller size made it particularly useful for German paratroopers who needed a weapon that was easier to move around, but still offered more punch than the diminutive 5cm leGrW 36.

It had a shorter tube than the standard 8cm mortar (tube length is 747mm), but it could still fire a round weighing 3.5x the earlier 5cm mortar weight, two times as far. Furthermore, at 26.5kg, it was half the weight of the leGrW 36. Maximum range was in the order of 1100m. Produced from 1941-45, the kz 8cm GrW 42 could be broken down into three loads for transport. Its effectiveness meant it served with Wehrmacht and other units as well as the airborne users it was originally intended for."

This is a very interesting publication. First of all, the title is misleading. This may be caused by the translation from the original Spanish and my lack of ability to do the same. If the word “Aircraft” is changed to “Aviation of the Japanese Imperial Navy” it would be more accurate.

Secondly this book is a continuation of Volume I. The interesting thing here is that the book apparently begins where the previous volume left off. By this I mean no preliminaries, such as a table of contents, publication data, or an index in the back. There is not even a prolog or introduction. It's like walking in when the movie is half over.

Quickboost now offers 1/32 scale builders a set of resin exhaust pipes for Hasegtawa’s Ki 44 Tojo kits. They are accurately sized, cast in Quickboost’s typical gray resin and feature remarkably thin sidewalls that capture the appearance of the Prototype’s exhausts quite nicely.

Unlike the kit parts that require modelers to glue together two halves to end up with a single hollow pipe, the Quickboost exhausts are already hollow and ready to use without any assembly. They are cast so they may be painted while still on the casting block. After removing them from the casting block, they will fit in place with absolutely no modification required. Just remember, because they are resin, they will need to be attached with super glue or an epoxy adhesive.

This set is recommended. My thanks to Quickboost and IPMS/USA for the review sample.