The latest release from Quick Boost is a complete set of resin exhaust tubes for the 1/32 scale A6M5 Tamiya kit. Once again the quality of the molding is flawless, no bubbles, or pin holes and the only flash is between pipes where there are more than one. I strongly suspect this is intentional for added strength while being shipped and handled. The resin is the light blonde color we have become accustomed to. And, of course, the ends of the pipes are hollow.

As can be seen in the photos of the packaging, each pipe is numbered and each number is referenced to the Tamiya part number that the part replaces.

If you have or anticipate getting a Tamiya 1/32 A6M5, you will want these exhausts to enhance the detail of the kit engine.

I can highly recommend this set.

This softbound book contains 264 pages of high quality photos taken by German occupiers printed on high quality paper. What I did not know was that pre-war Polish security concerns prohibited photos from being taken from 1937 until the war. That is why there are, according to the authors, only around 25 photos of pre-war Polish aircraft. Then after the invasion anyone seen taking photos was suspected of spying and detained, plenty of reason that there are so few photos. The German photos became the only source of knowledge and markings from the Polish Air Force. The quality of photos is very high even though most of the aircraft are in states of disrepair.

This review is a little different for me, only because I have taken over this task from John Yager, the original reviewer who started the initial work, but was unable to complete the build. However, I was still able to complete enough of this model to bring to you an honest and fair review. When I received the kit, Steps 1 thru 4 were underway, but needed to be cleaned up. Only the cockpit was complete and it was a job well done. The credit for the building should be shared with John Yager due to the hard & good work he put into what he had done.

ABOUT THE AIRCRAFT

(PLAAF) J-10A VIGOROUS DRAGON