This kit contains four light-gray resin sprues with a total of seven parts, which are finely cast and contain an amazing amount of detail given the small scale. The parts are very delicate. I highly recommend that you use a fine-tooth hobby saw to remove them. Any attempt to snip them with a sprue cuter will result in damage.
No instructions are provided; however, the construction is very intuitive. I began with using CA to bond the back wall and floor and used the grid lines of a cutting matt to ensure a 90-degree angle. Next, I added the left-hand side wall and after the parts were sufficiently bonded, I attached the two parts which make up the commode seat. Lastly, I added the right-hand side and then the roof and door. The door has a nice little heart shaped opening, but this needs to be cleaned up a little bit to make the heart shape recognizable.