History

The Messerschmitt Bf-110 was an early attempt by the Luftwaffe to develop a long range strategic fighter for deep penetration missions. It was also intended as a long range escort for bombers, as an interceptor against enemy bomber formations, and as a light bomber and ground attack aircraft. The first prototype flew in 1936, but protracted engine development kept the Bf-110 from entering service until 1938 as the Bf-110B. In 1939, the Bf-110C went into production, and this was the first version produced in large numbers. The Bf-110C appeared in fighter, ground attack, reconnaissance, and “destroyer” versions. The Bf-110C was used to effect in the Polish campaign in 1939, and this gave Goring the impression that the type was unstoppable, the ultimate air weapon. After success in shooting down unescorted RAF Wellington bombers, the type was committed in Norway and Denmark, and later during the Battle of France.

The Kit

The kit is cleanly molded in 154 pieces of multi-colored plastic. These parts are the same parts used in constructing many of the other 1/72 offerings from MiniArt. No flash is apparent and detail is very crisp on all parts. A new part that I have not seen on this model was the introduction of a stone foundation.

Construction

Assembly of this kit was straight forward as all of the offerings before it. However, I took a different approach. On many of the other kits, I found that doing each wall with the end connectors tended to produce minor gaps at the corners. This time I decided to pre-build the corner assemblies and then add the walls. Also, I decided to paint parts separately before assembly. This approach offered a much cleaner look to the house, a departure from the worn down structures I had built in the past. The result was by far my favorite work of all of these kits I had done.

The Kit

Nearly 100 injection molded parts in tan plastic plus 2 black plastic treads. All parts exhibit crisp detail and are flash free. The muzzle of the main gun is not slide-molded so will need to be drilled out. Being a snap kit, all parts had a number of locating pins. All of them fit together without modification.